State discontinuity after switching

2,387 views

I'm simulating half bridge resonant converter. It works fine when I use diode in rectifier circuit but as soon as I use MOSFET it shows the state discontinuity error. I tried to simulate separately a center tapped rectifier which was working fine with diode but as soon as use MOSFET it shows the same error. I'm giving complementary gate pulse to both the signal. Where is the error and what shall I do to resolve this error?

asked Aug 21, 2019 by Pallavi (22 points)

Hello,

Without sending a model, it is not possible to help you with specific feedback. But see some information on our website: https://www.plexim.com/support/solutions/165

Regards,

Kris

commented Aug 23, 2019 by Kris Eberle (1,587 points)

Thanks Kris for the help. The error got resolved

commented Aug 26, 2019 by Pallavi (22 points)

Please log in or register to answer this question.

...

State discontinuity after switching

Please log in or register to add a comment.

Please log in or register to answer this question.