Facing Problem while connecying RT box with PC

Question

Hii friends,

I facing problem while connecting RT box to PC using Network license.I set the path for coder targets Successfully using PLECS preferences.In my coder window nothing is enabled.Please help in this regard.

Thanks in advance.

With regards,

Manikandan Raju

Answer 1

With PLECS 4.0, which you are obviously using, you need to switch to a fixed-step solver before the options in the Coder menu become available. This is no longer needed for newer PLECS versions.

Kind regards,

Oliver Schwartz

Comments

Thanks Mr.Oliver , I followed your instructions , Still I am getting error while building model.Target response 3, Host not found. Here I have attached the screenshot.
 

---

In PLECS, only enter the IP address (192.168.0.3). In a browser, for the web interface, add "http://" before it.

---

Still I am same old error (Target response 499). I have attache the screenshot.please check it.

---

Then it's probably still the McAffee web gateway. You may have to disable this software on your computer or configure it to allow access to the RT Box. However, this is definitely beyond the scope of our support.

---

Thanks Mr.Oliver. Now I can build the model. Today I reinstalled PLECS software in my university Laboratory system & followed the same procedure I did in laptop.Thank you very much for all your support.