Please take a minute to review and accept our Terms of Use.
Welcome to the PLECS User Forum, where you can ask questions and receive answers from other members of the community.

Many technical questions regarding PLECS are answered on the Technical Solutions page of our website. Tutorial videos, specific application examples, and pre-recorded webinars are available on our YouTube page. Please follow us on LinkedIn for the latest Plexim news.

PMSM control with Rotational Speed (Controlled)

0 votes
801 views
Deal all,

I want to use Rotational Speed (Controlled) in my PMSM with inverter model.

However, when I try to use it, there is error same as below

1)State/source dependence in components
- 210208_SingleInverter_speedload/PM Machine/Inertia
- <hidden component>

2)Inconsistent source
- 210208_SingleInverter_speedload/PM Machine/Inertia
- <hidden component>

 

I thought it is the same as speed load in MATLAB/SIMULINK.

but it isn't

Please let me know how to use it.

 

I attached error and figure of circuit
asked Feb 8, 2021 by oming0731 (27 points)

1 Answer

+1 vote
 
Best answer

Set the machine's Inertia parameter to zero, as shown below.

From the PLECS Documentation: "A speed source may not be short-circuited or connected in parallel with other speed sources, nor may a speed source directly drive an inertia."  Setting the inertia to zero overcomes this issue.

You can also read a bit more about the error message at this link for a deeper understanding.

answered Feb 8, 2021 by Bryan Lieblick (1,853 points)
selected Feb 8, 2021 by oming0731
...