Export Scope View in PLECS Blockset

Question

Hi,

I have a simulation model in PLECS. I have done a m-File so that the simulation runs several times one after another with different parameters. I would like to save the scope view for the simulations.

Is there any possibility to do so?

I know that there is a solution with the "To File" block but I would prefer to have the scopes.

 

Kind regards

Answer 1

Refer to the following excerpt from the PLECS Documentation + Simulation Scripts + Command Line Interface in PLECS Blockset.

 

You would then place the above 'ExportBitmap' command in your m-File to execute when you would like to capture the graphic (i.e. after each simulation run).

 

Comments

Thank you very much for your answer. It helped me a lot.

There is only one little problem left I have:

The simulation runs several times with different data exported from .txt datasheets.

Now I want to have the names of the .txt datasheets as 'fileName' of the exported Scope.

Do you know how I can do this (name the file after a string)?

 

Kind regards

---

Simply replace the 'fileName' string with a string reflecting your desired naming convention.