Please take a minute to review and accept our Terms of Use.
Welcome to the PLECS User Forum, where you can ask questions and receive answers from other members of the community.

Many technical questions regarding PLECS are answered on the Technical Solutions page of our website. Tutorial videos, specific application examples, and pre-recorded webinars are available on our YouTube page. Please follow us on LinkedIn for the latest Plexim news.

DC DC bidirectional converter

0 votes
131 views
So I have designed this bidirectional dc dc converter to charge and discharge a battery model into a load. The battery model is extracted from the link below:

https://www.plexim.com/support/application-examples/976

However, my model's performance is incorrect despite adjusting the pi control of the current. In buck mode, the converter doesn't operate. Can someone point out the mistake, and is there anything else to adjust in terms of the battery model other than the voltage and capacity parameters?
asked Mar 26 by storm121 (19 points)
@Storm121, i was wondering the possibility of writing to you directly through an Email. If this is possible here, kindly contact me on ezennayasamuel@gmail.com.

1 Answer

+1 vote
Your model is quite convoluted, not sure what the problem is. I don't think you need two controllers to start with. You can add those if you need different performance for charge / discharge. Also, I would suggest to use MOSFETs in a totem-pole configuration instead of IGBTs.

Your problem can be solved way simpler. See attached minimum working model.

Cheers

Falk
answered Mar 27 by Falk Kyburz (232 points)
Thanks Falk for the reply. I had a look at the model and I have a couple questions in regards to that. Would it be possible if you can briefly explain how the model operates of the model? My concern is that the dc dc bidirectional model is to be connected to a bidirectional ac to dc converter through a dc link. How would such an operation work with this model?

 

Thanks,

Michel
Hi Michel,

The model is a simple synchronous buck converter where I strapped on an I-type controller for low performance current regulation. I would have to guide you to the "Single-Phase Battery Charger" demo model found in the PLECS documentation for grid connected battery systems.  

For your research I can suggest the books "Fundamentals of Power Electronics" written by Erickson / Maksimovic and the book "Grid Converters for Photovoltaic and Wind Power Systems".

Cheers

Falk
Yeah I had a look previously at the single phase battery charger; however, it seemed quite complex with different ac dc and dc dc structures than the ones I used. The bidirectional flow wasn't implemented either. Is your model able to be adjusted to behave as a buck boost converter with constant current and constant voltage modes?

 

I also included a buck model. I get the correct charging voltage; however, my current is too high (800A) where as my desired one is 20A. Any suggestions in regards to that?
...