# Unsaturated and saturated releative permeability

**URL:** <https://forum.plexim.com/t/unsaturated-and-saturated-releative-permeability/2350>\
**Category:** PLECS\
**Tags:** hysteretic-core\
**Created:** [July 19, 2025, 8:22pm UTC](https://forum.plexim.com/t/unsaturated-and-saturated-releative-permeability/2350 "2025-07-19T20:22:01Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![ATYIA](https://avatars.discourse-cdn.com/v4/letter/a/fbc32d/32.png) [@ATYIA](https://forum.plexim.com/u/ATYIA)\
**Post date:** [July 19, 2025, 8:22pm UTC](https://forum.plexim.com/t/unsaturated-and-saturated-releative-permeability/2350/1 "2025-07-19T20:22:01Z")

</div>

Hello,

I’ve been studying the “flyback\_converter\_with\_magnetics” demo model in PLECS, and I have a question regarding the magnetic core parameters used in the saturable inductor model.

Specifically, I noticed that the unsaturated relative permeability is set to 9550\*\*, while the saturated relative permeability is set to 1. According to the Ferroxcube datasheet for the 3C91 material, the initial permeability μᵢ is listed as 3000 (measured at 0.25 mT), so I’m trying to understand the reasoning behind using 9550 as the unsaturated value.

1. What is the source or method used to determine the unsaturated relative permeability of 9550 in this model?
2. Why is the saturated permeability set to 1? Is this a default approximation in PLECS to simulate full magnetic saturation, or is it based on specific physical measurements of the core material?

---

<div class="post-metadata">

**Author:** ![Kris\_Eberle](https://dub1.discourse-cdn.com/flex006/user_avatar/forum.plexim.com/kris_eberle/32/6_2.png) [@Kris\_Eberle](https://forum.plexim.com/u/Kris_Eberle)\
**Post date:** [July 21, 2025, 6:25pm UTC](https://forum.plexim.com/t/unsaturated-and-saturated-releative-permeability/2350/2 "2025-07-21T18:25:56Z")

</div>

Please see my answer on the other related thread you commented on:

> [@Magnetics permeability](https://forum.plexim.com/t/magnetics-permeability/1988/11):
>
> The 9550 value is an approximation. Looking at the BH curves in the material datasheet, you will need to determine the slope of the curve around H=0. Since neither temperature curve actually goes through the origin with these being the hysteresis curves, you are basically needing to eyeball the midpoint and do your own rise-over-run determination. As an example, if you draw a straight line from B=0 to B=100mT, this would bring us close to H=8A/m. Then, to determine mu\_r,unsat, you need to divi…

For the saturated permeability, yes 1 is the default approximation to simulate full magnetic saturation.
