AC Sweep to less Data Points

General
,
1

Dear PLECS Team
I would like to create a AC-Sweep with 11 Data Points between 49 and 51 Hz. When i start the Sweep it only creates one Data Point. this makes no sense to me.
Thanks for helping me.
Best regards,
Raphael
PFC_dreiphasig_Regelstrecke-bestimmen-six-switch-rectifier.plecs (75.0 KB)

AC-Sweep-with only one Data Point
AC-Sweep-with only one Data Point1153×711 37.2 KB

AC-Sweep-with only one Data Point (2)
AC-Sweep-with only one Data Point (2)1150×711 37 KB

2

The AC Sweep Algorithm will adapt the frequencies to prevent excesive simulation times. From the Analysis Tools + AC Analysis section of the PLECS Manual:

image

3

I understand. Are there other ways to increase the resolution in the specified frequency range?