Please take a minute to review and accept our Terms of Use.
Welcome to the PLECS User Forum, where you can ask questions and receive answers from other members of the community.

Many technical questions regarding PLECS are answered on the Technical Solutions page of our website. Tutorial videos, specific application examples, and pre-recorded webinars are available on our YouTube page. Please follow us on LinkedIn for the latest Plexim news.

Negative Loss Valiue for thermal model of the diode

0 votes
47 views
Attached is the simulation model for the single-phase multilevel converter, While I was trying to simulate the thermal performance of the switching devices.

However, whenever I start the simulation, it keeps telling me the power loss of the diode is negative.
asked Jan 23 by YuJin (17 points)
It appears you did not attach the model as you intended.
Sorry for the mistake. Now the model has been attached

1 Answer

0 votes

Hello,

While the concept of negative switching losses is confusing, if you look at the error message you will see that the device is used way outside its safe operating zone:

The device is seeing 20kA of current, which is causing a large extrapolation outside of the loss table data and causing an incorrect calculation of the result. In this case you have an issue with your model and should start there rather than worrying about the thermal losses. It looks like the individual devices are actually seeing approximately 100,000A current pulses in steady-state. You might want to unassign the thermal models and first debug the electrical circuit.

Regards,

Kris

answered Jan 26 by Kris Eberle (1,078 points)
...